Birthday Build-a-Dragon

To view this content, you must be a member of Dorte’s Patreon at $10 or more
Already a qualifying Patreon member? Refresh to access this content.

6 responses to “Birthday Build-a-Dragon”

  1. Omar Avatar
    Omar

    The Letter “S” will require support. Most likely also the letter “C, G, and Z” and maybe “E, F, and T” for a clean edge.

    1. sassiecat3d Avatar

      Thank you for your comment. I have printed these and they printed fine without supports for me. 🙂 You can ofcorse use supports if you prefer to, but it is not needed.

      1. Omar Avatar
        Omar

        OOPS, I noticed that I downloaded the old version of the dragon with the old links, my bad. As long as I already printed it, any advice on how to keep the links attached as it keeps coming out with movements?

  2. Emma Avatar
    Emma

    I love this model, it prints beautifully and is so sweet. I’ve printed it for several children’s birthdays and they were delighted!
    do you know how far down we can scale it (smaller) without affecting the strength of the connections? Thank you.

    1. EasyfragDK Avatar
      EasyfragDK

      Hi Emma

      Thank you for the kind words about the design!

      Sassie says she wouldn’t go down under 80% 🙂

      1. Emma Avatar
        Emma

        Super, thank you so much for your reply. ☺️

Leave a Reply

Your email address will not be published. Required fields are marked *